Goldline/Aqualogic SWG question

[tagprod]

Ok - so this cleaner all function. If the cell is set to 50% then it should be on for an hour and off an hour. Is the clean all supposed to override that setting. I think somethings wrong with the labeling due to my sheer descents turning on.

Pool is 18K gallons, getting a CYA test kit today. pump runs from 9AM to 5PM.

[mas985]

The cleaner is independent of the cell so that setting will not matter to the cell at all. However, the cell is tied to the filter pump and that is the only setting that really matters as well as the %. If the filter pump is on, the cell will go on for the first part of the cycle.

With 18,000 gallons, 50% setting and 8 hrs run time, you will be adding about 1.7 ppm per day which should be OK depending on you CYA. Check it after a day or two and see how it goes.

[tagprod]

The cleaner is independent of the cell so that setting will not matter to the cell at all. However, the cell is tied to the filter pump and that is the only setting that really matters as well as the %. If the filter pump is on, the cell will go on for the first part of the cycle.

With 18,000 gallons, 50% setting and 8 hrs run time, you will be adding about 1.7 ppm per day which should be OK depending on you CYA. Check it after a day or two and see how it goes.

Thanks Nas. It's been running like that for a couple of weeks. I need that CYA reading. Outside of the solar, our pools look to have similar equipment.

Are you thinking the cleaner is for the navigator that cleans the bottom of the pool?

[mas985]

Thanks Nas. It's been running like that for a couple of weeks. I need that CYA reading. Outside of the solar, our pools look to have similar equipment.

Are you thinking the cleaner is for the navigator that cleans the bottom of the pool?

Probably. Usually for suction side cleaners, a valve is turned such that suction increases for the cleaner port on the side of the pool, assuming you have one.