+ Reply to Thread
Results 1 to 2 of 2

Thread: Lowering Alk

  1. #1
    Join Date
    May 2006
    Location
    Sanford, FL
    Posts
    387

    Default Lowering Alk

    Okay - about a week and a half ago I started with TA = 160. Got PH to 6.8 and then turned on the spa jets. In 24 hours it was down to TA=90.

    So now mu PH hovers between 7.4-7.8 (new plaster pool). DH and I use the spa a few nights and yesterday my ALK =80 .

    Will it continue to drop because of the spa or will it naturally fluctuate?
    Completed 8/21/06
    14,000 gallon 3'-6' concrete pool with Diamond Brite
    Spa with spillway
    250K BTU gas heater (for spa)
    SWCG - Aqua Rite
    Hayward Super II Pump - Cartridge filter

    See pictures here http://www.philsimmons.com/family/ga...mages&keyword=

  2. #2
    chem geek is offline PF Supporter Whibble Konker chem geek 4 stars chem geek 4 stars chem geek 4 stars chem geek 4 stars
    Join Date
    Nov 2004
    Location
    California
    Age
    64
    Posts
    2,226

    Default Re: Lowering Alk

    Unless you add baking soda to your pool (or "pH Increaser" that happens to be soda ash or sodium carbonate), then your TA will never increase. It will slowly decrease as carbon dioxide leaves your pool, but it may do so very, very slowly once you get down to low TA levels (less than 80) and maintain the pH high enough (7.4 or higher), but the exact levels and rates are dependent on the amount of aeration you have -- higher aeration means faster outgassing of CO2 and faster pH rise and lowering of TA (though the TA measures a drop much more slowly than the pH rises, all else equal).

    This chart will give you some idea, but even my color coding of this chart is quite approximate and dependent on aeration. Nearly everyone experiences a noticeable pH rise (with TA drop over time) when in the red region and hardly anyone experiences one when in the green region, but there are exceptions. Also, the pH can change for other reasons so it's really watching the TA over time that tells you what's really going on.

    And yes, your spa is a good source of aeration so you will likely continue to experience some pH rise and slow TA drop. You can either live with that (and continue to add acid and eventually some baking soda) or you can let your TA drop even further (probably not below 50 in any event). You generally don't need much pH buffering if you are using bleach -- it's Tri-Chlor tablets that really need the 120 TA. Normally a spa would also need substantial pH buffering due to the small water volume and relatively high bather load so for the spa, at least, you'll probably have to live with adding acid more regularly (but at least it's not very much, given the low volume of water).

    Richard
    Last edited by chem geek; 08-29-2006 at 05:25 PM.

+ Reply to Thread

Similar Threads

  1. Lowering TA.
    By DennyB65 in forum Testing and Adjusting Pool Water Chemistry
    Replies: 9
    Last Post: 07-16-2011, 12:03 PM
  2. Lowering CYA
    By jrsdws in forum Pool Startup, Shutdown, & Winter Operation
    Replies: 13
    Last Post: 05-21-2011, 04:39 PM
  3. Lowering pH with CO2
    By Jakebear in forum The China Shop
    Replies: 11
    Last Post: 09-12-2006, 12:21 AM
  4. Lowering pH with CO2
    By Jakebear in forum Testing and Adjusting Pool Water Chemistry
    Replies: 7
    Last Post: 09-08-2006, 07:22 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts