1st time I will close the pool by myself (as this was the 1st time I opened it thanks to the board)

I have read Carl's post on how to prepare the water for closing and I think I've got most of it:

http://www.poolforum.com/pf2/showthr...hlight=closing

My questions is:

What steps do I need to take to prepare the pipes/pump/filter for closing.

I have an IG 40x20 vinyl liner with 1 skimmer line, 1 suction line and 1 return. A DE filter and pump (housed) and I am in SE PA.

I know I have to lower the water (below the skimmer?)

I know I have to drain the filter

I know I should clean out the pump basket and the filter grid.

How do I blow the lines and prevent water from getting back in them prior to getting the plugs in?

I know I need to pour some antifreeze into the skimmer but how much and how do I pour it into the return and suction lines?

Do I pour any antifreeze over/in the pump/filter?

What position should I leave the multiport in. Any other things I should check/clean/store for the winter?


finally with regards to Carl's post, is a Qt. of Algeacide adequate for my pool? My CYA is on the lower side (30) should I float a few pucks in the pool as well?


Thanks in advance!