SWG and pool

[deep_blue]

No problem on information

pool size 300 gallons (a baby... on this forum, but lots of fun and plenty of water to swim)

stainless panels in the pool

where the panels almost touch -><- get a very small amount of soft lump of rust that will disappear when you move water over it ... the "poof effect"

happens only in a few places 4-6 I can see over a few days.

SWG Jandy 700 Aquapure (seems fine on lower settings and timer with pump, due to our low chlorine / organic loads in the indoor pool)

PH seems to rise slowly and I use sodium bisulphate to lower PH ... it cleeps up over a 2 week period so a small amount and then PH is 7.4

All of the pool frame and outside panels are grounded bonded to a common
ground point. The interior bench and swim motor housing is not ... from what I can see, there is supposed to be a series of screws that go through the swim motor housing to the metal panels behind the liner. Just can bring myself to poke hold through liner

covered for safety & humidity control

If you need any other information just ask.

I want to get this pool to its best possible place. The ORP chemical unit seems like a great way to control.

I am at

PH 7.4
TA 100
FC 4+
CC 00

thanks all
deep_blue