Calibration procedure for AquaLogic Salt Level

[PatL34]

Yes there is. It should be spelt out in your manual.

Pat

[joelq]

Thanks, Pat. Can you point out where it is in the manual? I've look through all the documentation I have and can't find any. Thanks!

[mas985]

joelq,

I have the same controller as you but purchased last year and at least for my version of the unit, I do not believe there is a calibration. You can reset the salt reading with the instaneous salt reading through the diagnostic menu but that is about it.

[joelq]

Thanks, Mark. I just did a drop test this evening and according to the Taylor test kit, I have 3600 ppm, and the PS-8 is showing 2900 ppm! Do you know how low I can take the salt level and the PS-8 not complain of "low salt"? 2700?

[mas985]

I think I remember having mine down to 2600 once without shutting off but if you want to know the exact limit, I suggest calling Goldline. They are pretty good at answering those types of questions. For example, I found out from them that the upper limit on salt is derived from 8 amps of current before a high salt warning shuts off the cell.

[rpoldervaart]

Unless it has something to do with the += salt button in the diagnostics display, I don't think there is an obvious calibration on the Aqualogic. Someone posted a couple weeks ago that you can call Goldline and they'll maybe tell you if you do your own service work.

If anyone gets this, please post the instructions.

Thanks,
Robert

[PatL34]

If that salt button is the adjustment, then I would give it a try. I too checked the manual, and was surprised at the lack of detail.

I know I can adjust it with the PoolPilot controller.

Pat