We have a Jacuzzi Cygnet pool pump. A few days ago when I went to turn it on, it would not prime. It sometimes takes a few minutes to prime, but there is always at least some water being pulled into it. This time there was nothing, even after letting it run for about 3 minutes. It sounded the same as always. We have taken it apart (sorta) but we can't find anything that seems like it would cause this, the impeller looks fine, and the o-ring is a little chewed up but it doesn't look bad enough to cause this. What else should we try? We would appreciate any help or advice you all might have.

It has been days since we could run the pump, and our pool is a swamp!! Help!!


Thanks in advance,

Stephanie