restested my water this morning
FC 5 ppm (no change)
CC 0 ppm (no change)
pH 7.5 (no change)
TA 120 ppm (before stabilizer correction) (no change)
TA 97 ppm (after stabilizer correction) (no change)
CH 220 ppm (no change)
CYA 70 ppm (no change)
Salt 3600 ppm (It is hotter today, the pool water is at 92 degrees so this might be the reason for the higher salt reading...once again using the display on the Aqualogic)
Borates about 40 ppm (measured with AquaCheck borate test strip) (no change)


I added 2 more boxes of borax and 1 quart acid.

Restested pH and borates
pH is off the scale so I added another quart of acid and will retest in a bit.
Borates reading a bit higher than 50 ppm but not as high as 80 ppm. I guess 1 and 1/2 boxes would have been perfect. Once I get the pH corrected I am going to turn on the spllover and dump the spa water into the pool. I will let the system circulate for several hours and then recheck the borates. It might be just enought dilution to get me right on the 50 ppm mark!