Started my stain treatment yesterday morning. By mid-day today the water was clear, not crystal clear, but I could see the bottom of the 6 foot deep end. Added 2 lbs of Super Sequa Sol yesterday at 3 pm and today I started the process of raising my PH up to 7.2.

We just received about an inch of rain and now my water is all cloudy again.

What caused this?

Did the additional water volumne dilute the sequester and the metals are falling out of solution or is it something organic caused by the rain.

Prior to starting the stain removal I added a bottle of Poly 60, about twice the recommended rate two days before the start of treatment.

The pool surface looked pretty good with the only staining remaining was a small patch that was barely tinted by one of the returns where the stain was the worst. So, I wasn't going to begin adding chlorine until tommorrow am to let the acid work still on this spot overnight.

OK, what do I do now? Add more sequestor, begin adding chlorine at 16 oz at a time, more Poly 60? The chlorine is the 12% liquid bleach. I don't want to be in a situation where I'm going to need to shock the pool.

13500 fiberglass IG
SWG - not operational during stain treatment.
TC 0
PH 6.8
ALK 80
Temp 82
CYA 40

Thanks, Bob