Green Water

[MaxxFusion]

Any paticular number that are more important than others? Obviously the Chorline level will be very high?

Should I leave my filter on overnight?

[Watermom]

Yes to running the pump 24/7 while you are clearing the pool. We really need a complete set of results - especially chlorine, ph and cya levels.

[MaxxFusion]

CL is too high to register
PH is about 7.8 or a touch lower
CYA is 30

[aylad]

Run your chlorine up to 15 ppm, hold it there by testing and adding bleach 2-3 times daily, keep your pump running while doing this, backwashing as necessary. You also need to be brushing daily. Keep this up until the water goes to cloudy blue, then let your Cl level drift back down and keep your filter running to clear out the dead algae.

Janet

[MaxxFusion]

Thank You. This morning my water is a translucent green and the Cl was pretty high. I dont know how to tell if its 15ppm or not I just know that its high. Probaly right around there.

I will brush and clean my cartridge when I get home today.

[aylad]

You need to get a drop-based test kit and test your water....."probably right around there" won't clear up your pool.

Janet

[Watermom]

Jan is right, you need a good test kit. Most of us use the kit that Ben sells at the sister site to this forum at www.poolsolutions.com. In the meantime, you can get higher readings with your kit by diluting your sample. Mix one part pool water and one part distilled water, test as usual and then multiply the result by 2. If you need to go higher, one part pool water and two parts distilled and multiply results by 3, etc.

[MaxxFusion]

You need to get a drop-based test kit and test your water....."probably right around there" won't clear up your pool.

Janet

I do have a drop based kit that will allow me to do a multiple of test. The CL reading will only go up to 5ppm though.

I came home today and the water is cloudy and tested the CL It was on the low side at about 1ppm so I added more bleach. i still need to clean the walls.