A Cheap Pool Cooler

[tclemmer]

I would be interested in a part list for your invention. Most importantly, the parts needed to connect to the output jet.

Tom

[duraleigh]

Tom,

Once you remove the eyeball base with the key (see above), what you have in the wall is 1.5" pvc female threads. (Not on all pools but most IG's)

Simply screw in a 1.5" male thread connected to a 90 and bring the 1.5" pipe up about 6" under the surface. "T" that pipe and reduce down to 3/4" on both sides of the "T".

Then, with T's and a 90 on each end, put however many vertical 3/4" sprayers you want, along that 3/4" pipe. drill a hole in some end caps (I used 1/4") and glue them on the top of the verticals. You can make out the outline of it in one of the pics

Whole thing took me a couple of hours of thinking about it and probably an hour or so glueing it together. You can get as creative as you want with the number of sprayers, angles of the sprayer, hole sizes, etc. The idea is to get a lot of water high into the air and let the evaporative process work.

While in the pool, I caught the falling water in an insulated cup with the pool temp guage in the cup. Temp in the cup was 78 degrees on a 93 degree day. Not bad for 6 bucks.

[hulla]

Where do you get the threaded fittings? From a home improvement center (Home Depot) or a pool store (Leslies)?

[aquarium]

Where do you get the threaded fittings? From a home improvement center (Home Depot) or a pool store (Leslies)?

Home Depot, in the plumbing section. Most pool returns are 1.5" but you might want to remove the eyeball fitting first to be sure.

[duraleigh]

Hulla,

They are standard pvc fittings readily available at any HD/Lowes....there's nothing extraordinary about any of the parts. The bushings that reduce the 1.5 inch pipe down to 3/4" might be a little tough but I picked them up at Lowes....the first place I stopped.

[tclemmer]

Tom,

Once you remove the eyeball base with the key (see above), what you have in the wall is 1.5" pvc female threads. (Not on all pools but most IG's)

Simply screw in a 1.5" male thread connected to a 90 and bring the 1.5" pipe up about 6" under the surface. "T" that pipe and reduce down to 3/4" on both sides of the "T".

Then, with T's and a 90 on each end, put however many vertical 3/4" sprayers you want, along that 3/4" pipe. drill a hole in some end caps (I used 1/4") and glue them on the top of the verticals. You can make out the outline of it in one of the pics

Whole thing took me a couple of hours of thinking about it and probably an hour or so glueing it together. You can get as creative as you want with the number of sprayers, angles of the sprayer, hole sizes, etc. The idea is to get a lot of water high into the air and let the evaporative process work.

While in the pool, I caught the falling water in an insulated cup with the pool temp guage in the cup. Temp in the cup was 78 degrees on a 93 degree day. Not bad for 6 bucks.

Thanks Dave, I think I will give this a try this weekend. I am in the Dallas/Ft. Worth area and we are seeing temps in the 104 range. My pool is sitting at 92 right now, would love to get it back to 86 or so.

Tom