+ Reply to Thread
Results 1 to 6 of 6

Thread: 1st test results--what a mess!

Hybrid View

  1. #1
    Join Date
    Jul 2006
    Posts
    12

    Default Re: 1st test results--what a mess!

    The pool looked a bit cloudy this morning so I ran some more tests and here is where I am
    FC=13.5
    CC=0
    TC=13.5
    pH=7.2
    Alk=150
    Cal=400
    Cya=150 (as far as I could tell)
    Temp=92

    Same as where I started....
    So I took a sample of my water to the local Shast...Store here in AZ and here are there results of my water...

    FC=5 (I asked them and they said that is as high as we go on FC. hmmm....)
    CC=0
    TC=5
    pH=7.4
    Alk=150
    Cal=660
    Cya=284
    Temp=92

    Now I am not sure what to do other than maintain the CL level and try to bring down the ALK 30 pts. which I am attempting to do with Ben's method of aerating. I would like not to draing the pool until the end of the season, when it is do for a resurface and remodel. Can I limp along with this?

    thanks

  2. #2
    KurtV is offline Registered+ Widget Weaver KurtV 0
    Join Date
    Dec 2004
    Location
    Mandeville, LA, USA.
    Posts
    418

    Default Re: 1st test results--what a mess!

    I think that your high alkalinity may be a red herring. Low chlorination for your CYA level is a more likely cause of dullness/cloudiness.

    The Best Guess chart calls for an 8-15 ppm chlorine maintenance level for a CYA level between 100 and 200 ppm and your CYA may be well over 200. If that's the cause, the only cure is to consistently maintain a higher chlorine level.

    The other strong possibility is that your high calcium is causing the problem; other than partial draining and refilling, I don't know of a solution for that.

  3. #3
    duraleigh Guest

    Default Re: 1st test results--what a mess!

    Hi, Max,

    Please copy your post, delete your post from this thread, and paste it into a new thread that you start. That way, you'll get your own advice and we can keep this thread for "azhobbs".

    It's too confusing to help two folks on the same thread. You'll get lots of advice starting your own.

+ Reply to Thread

Similar Threads

  1. Taylor 2006C test kit mess
    By PJM361 in forum Pool Chemicals & Pool Water Problems
    Replies: 11
    Last Post: 07-09-2012, 08:14 PM
  2. Test results vary between meter and drop test - not sure what to do?
    By west1745 in forum Salt Generators (SWCG) & other Chlorine Feeders
    Replies: 14
    Last Post: 07-29-2006, 03:27 PM
  3. Test Results
    By goyettes in forum DPD-FAS based testing
    Replies: 1
    Last Post: 07-06-2006, 03:59 PM
  4. 1st test results
    By mtsteen in forum Testing and Adjusting Pool Water Chemistry
    Replies: 2
    Last Post: 07-06-2006, 08:30 AM
  5. First 234s test results and warning about pool stores' results
    By SoCalBoo in forum DPD-FAS based testing
    Replies: 1
    Last Post: 06-16-2006, 01:48 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts