Hi Sean

I just installed a new Autopilot Digital with a 48 cell about a week ago and I'm not getting the power setting settled down very well.

Every time I look at it, the power setting is different and sometimes miles from what I set it at. I started running at level 2 with 50%, the factory default.
With 12 hours running a day 6AM till noon and 6PM till midnight I was getting
too much. So I tried setting it back to 40 > 30 > 20 then reset the power level to 1. I've set it as low as 10 % only to find an hour later it says it's outputting 41% or 60% ... seems like a random number generator.

Is this all the auto temp compensation ???
How am I supposed to know if my original setting of say 25% is OK if it says its been jacked up to 55%. If I re-set it while it says 55% ... what am I really re-setting, because my base number that I put in was 25%.

=============

Can you also give me the power ratios for the different levels 1, 2 and 3?
The book does not even say which is the highest output. One assumes 3 is the greatest output but you know where assuming can get you sometimes.