Question for PentairTech on IntelliTouch

[mshumack]

The firmware is not the same on the IntelliTouch and MobileTouch. I think (I'm not home right now so this is from memory) I have version 1.05 on the MobileTouch and 1.04 on the in-house control unit.
How do I update?

Thanks,
Mike

[mshumack]

I'm home now. The Outdoor controller (U.O.C.) is version 1.060, the IntelliTouch indoor controller (U.I.C.) is version 1.025, and the MobileTouch is version (U.I.C.) 1.060.
How do I update the firmwear version?
-Mike

[pentairtech]

I sent you an email.

[Mountain_Man]

Page 77 of the link I provided earlier provides the details.

Basically what you do is this: Menu>Settings>Advanced Press Buttons 2&4 (Heater & Exit buttons on the main page) simultaneously. That will take you to the Service Personnel Screen. Choose Get Image From Outdoor that should bring you up to the same rev as the outdoor controller and MobileTouch. The stopwatch icon will flash until complete. When done check to make sure you updated to the 1.06 rev then exit back to main panel. The procedure for checking revs is on pg 76 of the referenced manual.

Good luck.

[pentairtech]

That does not upgrade your firmware though.

[Mountain_Man]

Ooops I missed the fact that PentairTech had already replied via email. But this does give me the opportunity to revisit the question that mshumack asked earlier about updating the firmware for the system controller. Normally the process for updating micro controller firmware is to download the image from the mfgs. web site then use the appropriate connection (LAN, Disk Drive, USB port, etc.) to update the controller image. How do you do this with the IntelliTouch System outside of purchasing a new eeprom or system board?

[Mountain_Man]

Ahhhh....so it is just the system config that comes over as the image. Good to know. Usually when the term "image" is used it implies system os as well as configs.

[pentairtech]

At the factory we have a com port and we flash the boards their..
If you get image from out door all you do is retrieve proraming information but no firmware.

[Mountain_Man]

So basically there is no option for field applied firmware updates to the controller or any of the remotes?