Just wondering if anyone else has had this problem.

When the solar is turned off and then back on, I get a high salt warning. After I reset the SWC, the salt level is fine (3200 ppm). I don't get another warning unless the solar is turned off and then back on again. The warning is fairly repeatable and I can watch the salt level rise on the controller when the solar is first turned on.

I suspect that the panels do not fully drain while the pump is on because of the pressure on the one-way valves. Salinity in the 20 ft vertical pipes up the house probably rises to the top over time making some of the water a higher salt ppm.

This is not a huge problem but the Aqualogic controller has a 100 minute cycle which means I lose chlorination during that cycle. Unfortunately, the controller does not turn the cell off for a delay when the panels are turned on. For changing the spa/pool valves, it does delay the cell.

Thanks