+ Reply to Thread
Results 1 to 4 of 4

Thread: Stains and test results..........

Hybrid View

  1. #1
    Join Date
    May 2006
    Location
    Downingtown, PA
    Posts
    192

    Default Re: Stains and test results..........

    Marla,
    I think there may be a problem with your test results. The TC (total Chlorine) should always equal FC (free CL) + CC (combined CL). According to the results the FC is 7, TC is 3 and CC is 0 which is not possible. I would double-check these because if the FC is 3 and TC is 7 you have a TON of CC in that pool that needs to be shocked out. Also, I would drain and re-fill to get the CYA below 50. Since you mention wanting to use pucks throughout the summer you might want to get the CYA down to 30.
    Outside of Philadelphia, PA
    18' x 40' IG - 22K gallons
    Sylvan Gunite Pool (1979)
    Plaster re-done (1997)
    48 Sq Ft Hayward D.E. Filter (2003)
    1.5 hp Hayward Super Pump (2006)

  2. #2
    ozres is offline ** No working email address ** ozres 0
    Join Date
    Jun 2006
    Posts
    4

    Default Re: Stains and test results..........

    You're right Bleach=Chlorine.......the TC is 7.0 not 3.0! (My typo!)

    Marla

  3. #3
    Join Date
    May 2006
    Location
    Downingtown, PA
    Posts
    192

    Default Re: Stains and test results..........

    Marla,
    Ok that sounds a lot better! I have a decent amount of staining from leaves, etc in the bottom of my plaster pool and I am not sure how effective treatments are. I think you have to drain and acid wash to clean real bad stains -- Was told by my pool man that helped with inspection(not store). I have not used any stain products so I can not comment on the effectiveness.
    Outside of Philadelphia, PA
    18' x 40' IG - 22K gallons
    Sylvan Gunite Pool (1979)
    Plaster re-done (1997)
    48 Sq Ft Hayward D.E. Filter (2003)
    1.5 hp Hayward Super Pump (2006)

+ Reply to Thread

Similar Threads

  1. Results of Ascorbic Acid Treatment for Stains
    By Cookieman in forum Dealing with Stains & Metals, . . . and 'Minerals' & 'Ions',
    Replies: 38
    Last Post: 09-12-2012, 04:11 PM
  2. First test results are in ...
    By swimlane in forum Testing and Adjusting Pool Water Chemistry
    Replies: 1
    Last Post: 06-04-2011, 12:17 PM
  3. Test results vary between meter and drop test - not sure what to do?
    By west1745 in forum Salt Generators (SWCG) & other Chlorine Feeders
    Replies: 14
    Last Post: 07-29-2006, 04:27 PM
  4. Stains and test results..........
    By ozres in forum Dealing with Stains & Metals, . . . and 'Minerals' & 'Ions',
    Replies: 3
    Last Post: 06-21-2006, 12:08 PM
  5. First 234s test results and warning about pool stores' results
    By SoCalBoo in forum DPD-FAS based testing
    Replies: 1
    Last Post: 06-16-2006, 02:48 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts