Re: Replacing a motor on a pump, and getting the correct size for your pool?
After being down for a week, I wanted to get it going. I have an Intermatic T10604R timer to control it, but it's not hooked up yet. Probably should have the electrical ready for it by tomorrow (there was NO timer control whatsoever prior to this whole ordeal.)
I'll probably have it on low most of the time, shutting it down for about 6-10 hours a day at first, until I figure out how much I actually need to run it to keep it clean. Our yard has arbor vitae trees as a privacy fence around our whole yard, so the debris from them lands in the pool all the time. Probably can't shut the pump off completely for very long.
26,000 gal IG vinyl liner pool (20'x40'), Waterway SMF-110 wet end w/ Century SQS-1072R motor, Pac-Fab Triton TR60 sand filter, K-2006A. Manually added chems: 12.5% NaClO liquid, granular CYA, baking soda, 31% muriatic acid.
Bookmarks