Sounds like a pretty big project to me. Point 2: How are the skimmers? Point 3 sounds like an issue you should address. Hopefully someone with experience in this area will chime in. Good luck
Sounds like a pretty big project to me. Point 2: How are the skimmers? Point 3 sounds like an issue you should address. Hopefully someone with experience in this area will chime in. Good luck
26K gal 20x40 rectangular IG vinyl pool; Apr 2014: New pump, liner, auto-cover, & water; Pentair Whisperflo 1HP pump; Pentair Trition sand filter; Cover/Star CS-500 auto cover; Taylor K-2006C; OTO
1) Since they usually remove the old plaster, I think it is ok to leave it. They will probably power wash anyway.
2) Not a big deal: http://www.poolinspections.com/manua...out-drains.pdf
3) You could probably seal the cracks but it depends on how large they are.
4) I would suggest changing to PVC but the size depends on the applications. In most cases, you shouldn't need more than 2.5" unless it is a high volume spa (> 6 jets).
5) Depends on the condition
Mark
Hydraulics 101; Pump Ed 101; Pump/Pool Spreadsheets; Pump Run Time Study; DIY Acid Dosing; DIY Cover Roller
18'x36' 20k plaster, MaxFlo SP2303VSP, Aqualogic PS8 SWCG, 420 sq-ft Cartridge, Solar, 6 jet spa, 1 HP jet pump, 400k BTU NG Heater
Bookmarks