Hello all,
My wife and I had a new pool put in our backyard a year ago. The pool is a 17,000 gallon in-ground plaster pool (mini-pebble) with a cartridge filter (4 large cartridges).
I have been having a high PH in the pool since it was put in, usually about 8.2 with my Alkalinity usually sitting at 90-100. My weekly routine has been this: Since I’m going to have to add about 74 ounces of Muriatic Acid to lower the PH and I know this will also lower my Alkalinity, I start with adding 4 lbs of Baking Powder to increase the Alkalinity to 120, then add my 74 ounces of Acid to bring the PH down to 7.2 and the Alkalinity back to 90-100.
Today I did my pool test and my Alkalinity was actually at 80 and my PH was at 8.2. To this, I am not sure what to do. Honestly, I’m at a loss altogether because I have friends who live in the same relative proximity to me and they claim they rarely have to add any acid for their PH. We built our pools at the exact same time. Surely I shouldn’t have to be adding this much acid each week, week in and week out?
I’m very close to just draining the entire thing and starting fresh. Any advice? I’m not sure where to go with 80 Alkalinity and 8.2 PH. If I add the acid it’s going to lower both and the Alkalinity will be very low and then the cycle starts itself all over again.
Thanks in advance
Bookmarks