BioGuard balance pak 100

[FormerBromineUser]

Great! What type of stabilizer product did you use and what is your CYA goal?

[jmarty462]

I used the BioGuard the PB gave me. From the research I've done on this sight and my SWCG manual my goal should be 80 but since I won't be turning it on for at least 3 more weeks I was shooting for 40 for now.

Marty

[CarlD]

OK. Do not add anymore CYA for a while--wait about 4-7 days, then test it again. CYA takes an ANNOYINGLY long time to dissolve, from 2 up to 7 days. Otherwise you risk overshooting your target.

Otherwise your numbers look pretty darn good. (don't know how you got "34" for CYA though--anything between 30 and 40 is a total guess--halfway is NOT 35!) Be sure to check the Best Guess Table at
http://poolsolutions.com/gd/best-gue...ine-chart.html
for the best FC levels for your CYA level.

[jmarty462]

Ya I guessed at 34, it was closer to 30 than 40. Anyway figured it was close enough for a week to let it all dissolve. I'm shooting for 4-5 for chlorine.
Numbers look good because of this sight. I've done lots of reading the past few months, so thanks to everyone that contributes to the knowledge pool.

Marty

[FormerBromineUser]

You are welcome! I just reread the thread and noticed that you said you added 55oz Hasa acid (31.45%). Please tell me you didn't measure it. If so, please read info on MA safety: http://www.poolforum.com/pf2/showthread.php/13111

[jmarty462]

I didn't measure the acid, just an estimate. I marked the side of the jug with a sharpie and sticky thread on this site, same one you linked.

Marty

[FormerBromineUser]

Oh, phew! 55oz just seemed like a measurement. Keep us informed of your progress!
Best,
Randy