OK- one thing I have learned is to order extra testing supplies, so while I am going through my DPD at a rapid pace, I have already ordered another one (i love amazon prime) so 2 scoops is fine.
on a related note: i wanted to ask about the plastic testing vial (Taylor gives it a strange name…I was reviewing their testing vid's last night). Just noticed a film inside the vial (i typically rinse,shake, air dry). I used dish soap today to clean it. Is this OK? (no info on vial cleaning anywhere)...
15K gal, 15x30 rectangular, in-ground, vinyl liner, Pentair ¾ HP Whisperflo on 24/7, Pentair Cartridge Filter(CCP240), Heater (gas), Automatic Pool Cover
Rinse it until all the soap is gone.
12'x24' oval 7.7K gal AG vinyl pool; ; Hayward S270T sand filter; Hayward EcoStar SP3400VSP pump; hrs; K-2006; PF:16
Did you dilute the pH sample? If so, what IS your pH?
I asked Mary Jo also to test her TA because her jets have been set to bubble on the surface since opening. (She has very strong flow from her jets and I had her reposition them). As far as I understand, yellow would be your endpoint for TA with high FC.
Last edited by FormerBromineUser; 08-29-2014 at 02:46 PM.
OK- tested pH with diluted sample (5:1) and got 7.6 but how do you calculate correct pH from there?
Took TA reading again and went from green to blue to yellow w/ 14 drops=140.
15K gal, 15x30 rectangular, in-ground, vinyl liner, Pentair ¾ HP Whisperflo on 24/7, Pentair Cartridge Filter(CCP240), Heater (gas), Automatic Pool Cover
Don't even worry about the TA, till everything else is OK.
Bookmarks