Hi!
Not sure there's anything to it.
Once you've installed your SWCG, before you actually start using it:
You'll need to add pool salt to your water to get it to about 3000ppm (You'll need either a drop test or test strips for this.)
You'll need to raise your stabilizer level (cyanuric acid, aka, CYA) to the manufacturer's suggested level--usually between 60 and 80ppm.
Good idea to have your pH and T/A at recommended levels, and, IMHO, the appropriate chlorine level for your CYA.
Then turn it on.
Do recognize that many above-ground pool manufacturers will void the warranty if you install and use an SWCG.
Bookmarks