+ Reply to Thread
Results 1 to 10 of 22

Thread: When to admit defeat and start over?

Hybrid View

  1. #1
    CarlD's Avatar
    CarlD is offline SuperMod Emeritus Vortex Adjuster CarlD 4 stars CarlD 4 stars CarlD 4 stars CarlD 4 stars CarlD 4 stars CarlD 4 stars
    Join Date
    Dec 1969
    Location
    North Central NJ
    Posts
    6,607

    Default Re: When to admit defeat and start over?

    Couple of things:
    1) 1 gallon of 8.25% bleach SHOULD add about 12ppm of FC to your pool
    2) When you measure your FC and CC, use the 10ml line and not the 25ml line. You'll use up your reagents too fast and the .5 measure for each drop is more than accurate enough.
    3) When measuring CYA do it the same way every time. I hold it at waist level and face into the sun. Then I spill the solution back into the squeeze bottle and do it again, at least once, sometimes twice, using the same solution until I'm satisfied I've gotten a good reading. The scale on the side is a log scale so halfway between 30 and 40 is NOT 35, it's less. Your guessing at "38" but it may be lower if it's not right on the "40" line.
    4) If your FC is 3 and you add a gallon of 8.25% bleach to your pool you'll be (nominally) at 15.
    5) You need to check and adjust your FC level at least 2x/day, preferably 3x until what you are fighting is dead. You CAN go a bit higher but may bleach the pool a bit.
    Carl

  2. #2
    Join Date
    Jun 2014
    Location
    NC
    Posts
    17

    Default Re: When to admit defeat and start over?

    Thanks, this helps a lot.
    Will report back in a few days.
    Hopefully with good news.

  3. #3
    Watermom's Avatar
    Watermom is offline SuperMod Emeritus Quark Inspector Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars
    Join Date
    Dec 1969
    Location
    Charleston, WV
    Posts
    9,345

    Default Re: When to admit defeat and start over?

    Only one tweak to the good advice Carl gave you. When you test CYA, you want the sun at your back.

  4. #4
    Join Date
    Jun 2014
    Location
    NC
    Posts
    17

    Default Re: When to admit defeat and start over?

    Quote Originally Posted by Watermom View Post
    Only one tweak to the good advice Carl gave you. When you test CYA, you want the sun at your back.
    Thanks, Watermom.

    In order to get a definitive answer, I asked the Director of Education @ Taylor Technologies, Wayne Ivusich, and he was gracious enough to pass along this bit of information:

    "the "correct" way to test for anything (not just CYA but for all the other tests, especially color-matching) is to NOT face the Sun. The Sun will alter you eyes' ability to match colors. The Sun should be behind you or on your shoulders. Never face the Sun. If it's an overcast day then it kinda doesn't matter!"

    You might want to put that in a sticky as Taylor's Instruction Manual doesn't address it.

    I don't know if we'll ever get our pool clear, but I'm certainly enjoying all the conversations about it.
    There's some nice people in this business.

  5. #5
    PoolDoc's Avatar
    PoolDoc is offline Administrator Quark Inspector PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars PoolDoc 5 stars
    Join Date
    Jan 2005
    Location
    Georgia
    Posts
    11,386

    Default Re: When to admit defeat and start over?

    Honestly, if you're not clear yet, you may want to consider draining, refilling, and then following the SSR (http://pool9.net/ssr/)

    I've ofter said in the past that pools are not that hard, but that they aren't forgiving, either. That's doubly true with the soft-side pools, like the Intex. With the seriously undersized pumps and filters that can just barely keep up with a normal, there's simply no extra capacity for cleaning a mess.

    If you have a cartridge filter, do make sure you get the Unicel cartridges, before you start up. Those seem to make quite a bit of difference.

  6. #6
    Watermom's Avatar
    Watermom is offline SuperMod Emeritus Quark Inspector Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars Watermom 4 stars
    Join Date
    Dec 1969
    Location
    Charleston, WV
    Posts
    9,345

    Default Re: When to admit defeat and start over?

    Quote Originally Posted by PoolDoc View Post
    Honestly, if you're not clear yet, you may want to consider draining, refilling, and then following the SSR (http://pool9.net/ssr/)
    Yeah, that's kinda what we thought and advised him up in post #2 in this thread. Especially since he said it would only cost $47 to do so!

    Quote Originally Posted by SpacemanSpiff View Post

    I don't know if we'll ever get our pool clear, but I'm certainly enjoying all the conversations about it.
    There's some nice people in this business.
    That's nice of you to say but......... we want you to get it clear so you can enjoy swimming. After all, that's what having a pool is all about!

  7. #7
    Join Date
    Jun 2014
    Location
    NC
    Posts
    17

    Default Re: When to admit defeat and start over?

    Purely for clarification [pun intended], we have well water and a pressure pump that automatically kicks out if you try to fill a pool as it thinks there's a waterline break.
    Our neighbors have city water @ much higher pressure and kindly allowed us to use their water and pay the $47 increase.
    1. I don't want to bother the neighbors again unless absolutely necessary. [We just filled it last June]
    2. I wanted to become educated in not only the proper way to start, but in what to do when things go awry.
    So far, I believe I'm achieving the objectives, even though one wasn't intentional.

    I would like to add, we're leaving on vacation for a few days, in a few days. Given the other numbers above and figuring I'll have the FC ~ 15 tonight [I added 1g bleach last night and will test when I get home], what can we do to best protect our efforts while we're gone?
    5.5k gal 18'x48" Intex Easy Set AGP. PF=18

+ Reply to Thread

Similar Threads

  1. Where do I start?
    By Ligoomba in forum --cleanup--
    Replies: 0
    Last Post: 12-07-2012, 02:58 PM
  2. Sand filter changed @ start of season ? HIGH PRESSURE @24 PSI FROM START
    By timmygreene in forum Pool Equipment & Operations
    Replies: 8
    Last Post: 05-21-2010, 06:48 AM
  3. OK, I'm no chemist, I admit it.
    By shadowman in forum Testing and Adjusting Pool Water Chemistry
    Replies: 4
    Last Post: 06-20-2007, 10:26 AM
  4. Help - where to start?
    By kevinm in forum Pool Startup, Shutdown, & Winter Operation
    Replies: 4
    Last Post: 10-01-2006, 06:05 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts