Polaris P935 nearly climbing out of my pool

[Big Splash]

Thanks for the reply. I did try the online chat a few times. No one got on the other end of the chat end the sessions kept timing out.

[JimK]

Thanks for the reply. I did try the online chat a few times. No one got on the other end of the chat end the sessions kept timing out.

[Big Splash]

Just to update;
I've run the P935 on bottom only mode and it works fine. It just stops climbing about 10 inches below the waterline and them continues. So, I'll just keep running it that way. I still brush my pool by hand once a week anyway just to be clean crazy.

Never did get through to Polaris tech support. I'm guessing they're swamped with others like me???

Happy Summer,
Splash

[JimK]

I'm glad you were able to come up with a solution. It stinks though that you weren't able to get through to Polaris tech support.

[Rockman59]

I have a Pool Shark unit for cleaning. There should be an adjustment somewhere around where your pump/filter/heater equipment are located. There is a valve handle that controls how much water is fed into the cleaner and that determines how fast the cleaner moves around the pool and how high it will climb the sides of the pool.

[Big Splash]

I have a Pool Shark unit for cleaning. There should be an adjustment somewhere around where your pump/filter/heater equipment are located. There is a valve handle that controls how much water is fed into the cleaner and that determines how fast the cleaner moves around the pool and how high it will climb the sides of the pool.

The P935 is electric (AC converted to DC at the control panel). It doesn't operate off any pump water flow. It be nice if you could adjust the way rises out of the pool at the waterline. I wonder if it can be serviced to make such an adjustment?

It works well the way I'm using it now. I just don't have the time to take it back to the Fool Store (pool store) to get them to mess with. I'm guessing they'll say it works as advertised anyway...