+ Reply to Thread
Results 1 to 10 of 23

Thread: Low pH, Hardness, Alk, where do I start?

Hybrid View

  1. #1
    Pappy is offline PF Supporter Widget Weaver Pappy 0
    Join Date
    May 2014
    Location
    Plano, TX
    Posts
    261

    Default Re: Low pH, Hardness, Alk, where do I start?

    Borax shouldn't hurt you SWCG. Lots of the folks here have SWCGs and use borax. A copper ionizer is built in to your SWCG. Where did you read not to put borax in a pool with copper, and what was the reason. I suspect the fear is that as the pH goes up the copper will start dropping out of the water and begin staining.
    Intex 15ftx4ft 4500 gal. 3/4 HP Pentair WhisperFlo pump. Hayward 21" sand filter. Taylor K-2006 & K-1106 kits. PF=27

  2. #2
    Join Date
    Jul 2013
    Location
    Oregon
    Posts
    15

    Default Re: Low pH, Hardness, Alk, where do I start?

    This is the thread where I read about borax/copper:

    http://www.poolforum.com/pf2/showthr...stant-to-Algae
    16'x48" Intex, 5061 gallons, Intex 1500gph filter, Intex SWCG #54601EG, Filling with water on 6/7/14.

+ Reply to Thread

Similar Threads

  1. Sand filter changed @ start of season ? HIGH PRESSURE @24 PSI FROM START
    By timmygreene in forum Pool Equipment & Operations
    Replies: 8
    Last Post: 05-21-2010, 06:48 AM
  2. zero hardness
    By poolgal in forum Testing and Adjusting Pool Water Chemistry
    Replies: 3
    Last Post: 04-01-2008, 01:54 AM
  3. Hardness
    By Lil Bit in forum Dealing with Alkalinity and Calcium
    Replies: 3
    Last Post: 08-16-2006, 09:25 AM
  4. Hardness
    By Lil Bit in forum Pool Chemicals & Pool Water Problems
    Replies: 3
    Last Post: 08-16-2006, 09:25 AM
  5. Hardness
    By Sunny32504 in forum Pool Chemicals & Pool Water Problems
    Replies: 1
    Last Post: 06-25-2006, 10:43 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts