Solar cover reel frustration
16 x 28 Oval pool
Inground vinyl pool
Hayward cartridge filter
Hayward Maxflo single speed pump
~12500 gallons
Rolling the cover to the reel is a simple one person operation.
Laying it back on the pool literally takes 10x longer. I cut the cover carefully so it fits exactly the surface area of the pool.
I am looking for suggestions in particular, when I reel the cover (16 mil) back to the pool that the bubble side faces down. The coping sticks out towards the pool by about 2".
In addition, since the instructions suggested the reel will have to be place where the radius ends (oval pool), the half circle always follow the longer end in the same direction. In 9 out of 10 times, I have to go back to the water to set it right.
The solar cover is such a hassle, however, its effectiveness in heating the pool is greater than what I hoped for. If someone ran into a similar situation, any solution you have tried and worked is appreciated.
Thanks in advance.
Last edited by PoolDoc; 06-06-2014 at 12:13 PM.
Reason: enable signature
12k gal 16x28 oval IG vinyl pool, Hayward cartridge filter &
Maxflo 1spd pump. PF=10
Bookmarks