Beaded liner problems

[bridrob]

Is it imperative that you use a shop vac to set your liner?
I have a Johnny weissmuller 24$ round in which we just replaced the liner. It was about 82° out, and the liner went in easily. I put about 6 inches of water in with no problem and turned off the hose because it was starting to get cool. By The next morning about 8 inches of the bead had popped out In 2 areas. It was replaced, but I realized that the liner was still about 3-4 inches from the wall as you went up the sides. I did not use a shop vac.

Any suggestions? I'm hoping.that it will stretch out o er the next few days. Should I continue to fill it, and as the water rises will the air get pushed out?.

thanks

[PoolDoc]

A shop vac can help you keep everything in place, while the water fills.

It sounds as if that's exactly what you are lacking: as the water rose, it pulled the liner down. With an overlap liner, if it pulls down, it doesn't matter as long as there are no wrinkles, and as long as there is still sufficient liner at the top.

Liners will stretch some . . . when warm. If you can stretch the liner EVENLY then it will probably be OK. What you do not want is to have to stretch the top 8" a lot to get things in place.

You might want to try this:

1. Leave the water in, but let it warm up. Use poured in 8% plain household bleach to maintain the water.

2. On a warm day stretch every thing into place. Then put a shop vac on, and start filling.