My pool pump motors hate me

[Straightleg]

Bought my pool 10-12 years ago. I installed it. Then put a friends pool in same time. Mine is 33ft, he only had room for a 20ft.
Bought packages came with the same sand filter and motor size from watsons.
He is on his second motor.
I am on my 5th motor. First motor lasted 2-3 months took it back they gave me another. I put all my pump, filter and parts in heated basement over the winter.
That motor lasted a couple of years then noisy, to noisy to sit next to pool.
Next motor 2 years, noisy bearing went bad.
Getting to the point this hayard motor is one season old with my new xtreme cartridge filter. Opening my pool yesterday, Motor is super loud, it is one season old and it was stored in my unheated garage over the winter.
When I take a motor off, will have to put a new one on while the old one gets rebuilt or i throw the darn thing in the garbage. I have a rebuilt motor on my delta unisaw tablesaw that is 23 years old What is up with these pool filter motors.
What do I do. My pool pump motors hate me.



SL

[Watermom]

My pool pump motors hate me.

Your last sentence made me laugh! I'm sorry I can't help with this one but someone will be able to. Just wanted to say thanks for the chuckle!

[Straightleg]

Your welcome...

I have tried 220 volt, inground pool pump, 3 different 110 pumps, sand filter, now hayward xstreme 150, with 1.5 hp motor that came with it.
I have all 1 1/2 lines, maybe 12 ft total, pump is right next to pool. Heavy duty clear plastic lines 3ft from 1 1/2 line to intake and return.

I need a quite motor, so I can leave my windows open at night.

I need info before I buy anything else. I think I have around 28,000 gallons of water

Thanks
SL

[mas985]

What pump model do you currently have?

I think the Matrix came with that filter but I want to make sure. That is normally a fairly reliable pump so there must be something about your installation that is causing issues with the pump. Can you post a picture of your setup? Is there anything unusual in your setup?

I need a quite motor, so I can leave my windows open at night.

This assumes you actually need to run your pool at night. Given most pools can get away with less than 4 hours of run time per day, you could just choose a run time not at night. But also a two speed would really help the noise factor because you can run on low speed most of the time.

[Straightleg]

In the past, I have run 24/7..If I did not then algae would start forming on the bottom. I was not doing the bbb, so hope this makes a difference. Will go out now and take photos.
I have a very good electrician run my electric to pool for me

SL

[Straightleg]

Set up and electric



SL

[mas985]

Usually algae is more of a chlorine issue than a run time issue. If you were using trichlor (pucks) before and the FC level was too low for the CYA level, which happens a lot with pucks, then sometimes circulation can help a little but you are much better off getting the FC/CYA level correct than trying to solve the issue with pump run time.

[Pappy]

Here's the Amazon start page link.
http://poolforum.com/amz/

[Straightleg]

Here's the Amazon start page link.
http://poolforum.com/amz/

Thanks