ok just an update... a few days ago I put in about 8lbs of stabilizer and finally today my CYA is at a 52-53 (I'm in South Louisiana).
CYA: 52
PH: 7.2 <--why did this drop? Add Borax or baking soda? TA is low... does that mean baking soda woudl be better
FC: 5.6 ppm (when I tested it earlier--> shocked with 8 more gallons of 8% Bleach-> this should put my chlorine up to about 22ppm)
CC: 0.4 ppm
CH: 110 ppm
TA: 90 ppm

So my main question is what do I do next other than just brush the pool, keep the FC levels high >15 and wait for the pool to clear up? Should I try to adjust the PH at this point? Would I be better off using baking soda to do that in order to increase the Alkalinity too?

thanks for all of the help.

PS: I went ahead and did the side by side test that you asked me to do and here are the results from the Biogard Multi-test 1200-V

FC: 5 ish ppm <-- its harder to read and match than the taylor kit, but close, however the Biogard kit only goes up to 5 ppm for Free Chlorine.
PH" 7.2-7.5 <-- somewhere in between.. again its hard to read and match (taylor is much better)
TA: 110 ppm <-- same at Taylor test

thats all the test that the multi-test offers. For the most part its pretty accurate, but hard to read comparatively speaking.