btw i think i figured it out. the bottom picture I set it to 110 not 220. the old pump based on the pictures is set to 220.
I am replacing my pool pump and just want to be sure I wired this correctly. I think my old pump was 120v and set my new pump to 120 as well. Both say they can be either 220/120.
My old pump is a pentiar superflo.
Here is the old pump with the old wiring setup and the wiring diagram from the pump.
And here is how I wired my new pump a Hayward super pump
- - - Updated - - -
on my new pump i have the white neutral to L1 and the black hot wire to L2 I assume that is correct....
btw i think i figured it out. the bottom picture I set it to 110 not 220. the old pump based on the pictures is set to 220.
Maybe test the voltage with a VOM? They can be had for less than $10 and are an invaluable tool for any homeowner.
rectangle 11.5K gal IG concrete pool;; 125sf cartridge filter; 2hp 1 speed pump; K-2006, k-1766; PF:10
Please tell me that the metal flex I see in the last photo is a TEMPORARY hookup:
(from http://healthybuildingscience.com)
and that you are going to replace it with some type of LT conduit or UF cable!
PoolDoc / Ben
Did you look close at the before picture? I know my electrical inspector would fail the original and the new BX.
Yeah, I saw that. But I figured that's the past. It's the present . . . and that metal flex that worries me.
Bookmarks