Aquarite "No Flow" light.

[sw_stupid]

Just an FYI. You may not want to do it, but I got a blank "phone plug" and ran a loop wire between the two middle contacts and it fixed mine no problem. Of course, make sure you have flow etc. After I put my "plug" in I found out that mine was still under warranty. So I got one for free. (I still don't have it put in) The guy on the phone said mine would work fine as long as it was really flowing. Just unplug it during backwash. Just a quick and easy solution.

[Number6]

Thank you all very much.

The suggestions are very helpful.

Yes, I did leave the switch installed for the past 3 winters.

And that shorting tip was just what I was looking for !!

A new switch is on the way.

I'll keep you all up toi date as to the outcome.

Cross your fingers.........................

[Number6]

Thanks to you all !!

That switch shorting trick was the ticket.

It got me up and going until the new switch arrived; which was the root of the problem.

Again, thanks to you all.