+ Reply to Thread
Results 1 to 3 of 3

Thread: Evaporation changing chemical concentrations

  1. #1
    Join Date
    Jun 2013
    Location
    Central Florida
    Posts
    154

    Default Evaporation changing chemical concentrations

    Water loss from draining, leaks, splash out and carry out would take with it the same concentration of chemicals (FC, TA, CH & CYA) as found in the rest of the pool. So these kinds of losses would not change the results of a test of the remaining water. Of course filling the pool would then change the chemical concentrations based on the amount and chemical concentrations of the fill water.

    But what about evaporation? I would expect the water removed by evaporation to be chemical free ( or very nearly so). So in a pool with high evaporation losses, wouldn't these concentrations build over time? (At least for TA, CH & CYA).

    For example, suppose I have a CH concentration of 250 ppm with a full pool and I lose half the volume due to evaporation. Shouldn't I expect a CH concentration of 500 ppm now? If I refill with water having 250 ppm CH, shouldn't I expect a CH concentration of 375 ppm?

    I get a lot of evaporation losses. Our pool has NEVER EVER looked better since we started using the guidance provided on this forum. We are currently using cal-hypo to raise CH, but I'd like to know I f my assumptions are right so I don't go too far (or not far enough). Our fill water runs through a water softener and has a CH of 110 ppm.
    In-ground gunite 16 x 30 13,000 gal. Full screen enclosure. 120 sq ft. Filter cartridge, 1-1/2 HP pump. Master Pools In-floor cleaner. Taylor K-2006.

  2. #2
    mas985's Avatar
    mas985 is offline Lifetime Member Whizbang Spinner mas985 3 stars mas985 3 stars mas985 3 stars
    Join Date
    Dec 2004
    Location
    Pleasanton, CA
    Posts
    1,423

    Default Re: Evaporation changing chemical concentrations

    If you never replace the water and let the water level drop, then yes, the remaining chemicals would become more concentrated. But that doesn't typically happen in a pool. Most people replace evaporated water with fill water which then dilutes the chemicals back to where they were before the evaporation but with some added components. Fill water will normally contain CH and TA so over time CH and TA will climb.
    Mark
    Hydraulics 101; Pump Ed 101; Pump/Pool Spreadsheets; Pump Run Time Study; DIY Acid Dosing; DIY Cover Roller
    18'x36' 20k plaster, MaxFlo SP2303VSP, Aqualogic PS8 SWCG, 420 sq-ft Cartridge, Solar, 6 jet spa, 1 HP jet pump, 400k BTU NG Heater

  3. #3
    Join Date
    Jun 2013
    Location
    Central Florida
    Posts
    154

    Default Re: Evaporation changing chemical concentrations

    Makes sense. I guess I thought so. Unless fill water CH & TA were zero, the concentration will always climb.

    My finish was being etched from low CH & PH, but I didn't know it until I came here. I got my CH up to 250 last week, so I'm hoping the "sand in the bottom of my pool" diminishes and stops.
    In-ground gunite 16 x 30 13,000 gal. Full screen enclosure. 120 sq ft. Filter cartridge, 1-1/2 HP pump. Master Pools In-floor cleaner. Taylor K-2006.

+ Reply to Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts