RogerTexas

[Rogertexas]

I have a Polaris Autoclear Plus that continuely shows low salt. I have cleaned it per mfg directions and it starts off good, with all lights. After an hour or so it steadily decreases the value of salt content. Initial test shows 3300 the drops to 2700, 2600 ..... on down to very low salt then to Error 94. I verified salt levels are good. Any thoughts.

[PoolDoc]

Any thoughts.

Call Zodiac/Jandy, after carefully reading and following the trouble shooting process in the manual. Trouble-shooting electronic sensing is very specific, on model by model basis. I'm sure there are some specialist pool service guys in large markets that know ALL the models . . . but I'm not one of them. In general, only the manufacturer knows all the details of your model.

The fact that this is a discontinued model may cause you some problems, unfortunately. I did find a manual here:
http://cdn.bluehaven.com/downloads/AL103_reference.pdf (and made an archive SPR copy)

And some parts, here:
http://www.inyopools.com/pool_parts_...FVNp7AodOC8ATA

And an old thread on this topic:
http://www.poolforum.com/pf2/showthr...-Plus-Error-94

Good luck!