+ Reply to Thread
Results 1 to 10 of 23

Thread: Stains in Fiberglass pool

Hybrid View

  1. #1
    Join Date
    Dec 1969
    Location
    .
    Posts
    14

    Default

    Thanks, msehome, I'll give it a try. Does it turn your water cloudy when you add it?

  2. #2
    msehome Guest

    Default No Cloudy Water

    Not at all, its amazing to watch the stain dissappear right before your eyes. And the water stays clear.

    Good Luck

  3. #3
    Join Date
    Dec 1969
    Location
    .
    Posts
    14

    Default

    OK, I just ordered some. Can't wait to try it, thanks.

  4. #4
    mbar's Avatar
    mbar is offline Lifetime Member Whizbang Spinner mbar 3 stars mbar 3 stars mbar 3 stars mbar 3 stars
    Join Date
    Dec 1969
    Location
    Ashland, PA
    Posts
    1,009

    Default

    I also have a fiberglass pool, and I have learned to deal with the stains pretty effectively. When I get stains I use ascorbic acid, and a metal free product. The cloudy water is the metal free agent combining with the metal that has come back into solution. If you have a lot of metal in solution and the water is cloudy, you should not start to bring up your chlorine until the water is cleared - you can put a chlorine puck in the basket so the metals will stain the filter. You have to try and keep the ph around 7.2, not higher - it is hard to keep the ph there, because the stain treatment brings down the ph, plus the puck in the skimmer will add to lower ph. Be sure to keep your filter running 24/7 - once the water is clear, you can start to bring up the chlorine. I use regular bleach, and I don't run high chlorine levels - it isn't necessary especially if you keep your cya under 50. In my opinion, fiberglass pools tend to stain, I now treat it heavily at the beginning of the season with a metal free product, and keep the filter running 24/7 when I have high chlorine levels. All water and pools are different - you will have to experiment with yours to see where you need to keep your chlorine & ph to keep the stains away. Don't worry so much - if it stains, it can be taken care of!
    Northeast PA
    16'x32' kidney 16K gal IG fiberglass pool; Bleach; Hayward 200lb sand filter; Hayward pump; 24hrs; Pf200; well; summer: none; winter: mesh; ; PF:7.5

  5. #5
    Arizonaoldman is offline ** No working email address ** Arizonaoldman 0
    Join Date
    Dec 1969
    Location
    Bullhead City, Arizona
    Age
    83
    Posts
    10

    Default

    I too have a 21,000 gallon fiberglass pool and a salt to chlorine generator. We have extreamly hard water and I just had my generating cell replaced after only two years. (free of course) Last year I began to have brownish 'build-up" at, or above the water line only in two areas (both wind driven areas) I had been using a 'Bio Guard" product "Off the Wall" on a weekly basis until late last fall. This year the stains are quite noticeable and no amount of "Off the Wall" and/or elbow grease seems sufficient. Do you think the Ascorbic Acid trick will work for me? Remember that most of the stain is above the water line. Will scrubbing with the ascorbic acid do the trick.

    By the way I life in north western Arizona.

    Ralph

  6. #6
    mbar's Avatar
    mbar is offline Lifetime Member Whizbang Spinner mbar 3 stars mbar 3 stars mbar 3 stars mbar 3 stars
    Join Date
    Dec 1969
    Location
    Ashland, PA
    Posts
    1,009

    Default

    If the stain is above the water line, then I don't know how it would be from iron falling out of the water. You can tell if it is mineral by rubbing a vitamin c tablet on the stain. If it takes it off, then ascorbic acid would work. You wouldn't have to scrub with ascorbic acid - just letting it touch the stain will make it disappear. Let me know if the vitamin C tablet (you can put a couple in a sock, soak the sock and rub it on the stain) works. If it is stain from leaves, they come off after chlorine is on them for a while. I have also had good luck with cleaning the water line with magic erasers. Hope this helps
    Northeast PA
    16'x32' kidney 16K gal IG fiberglass pool; Bleach; Hayward 200lb sand filter; Hayward pump; 24hrs; Pf200; well; summer: none; winter: mesh; ; PF:7.5

  7. #7
    Arizonaoldman is offline ** No working email address ** Arizonaoldman 0
    Join Date
    Dec 1969
    Location
    Bullhead City, Arizona
    Age
    83
    Posts
    10

    Unhappy

    I tried the Vitamin C Tablet today. Got it wet then used it directly on the stain.
    No luck whatsoever. Tried Mr. Clean Magic Eraser yesterday, still no luck. I refuse to give up.

    Ralph

+ Reply to Thread

Similar Threads

  1. Fiberglass Pool Stains
    By ts8181 in forum Dealing with Stains & Metals, . . . and 'Minerals' & 'Ions',
    Replies: 1
    Last Post: 03-30-2013, 11:39 AM
  2. White splotches, spots, and lines (stains/fading?) in 3 year old fiberglass pool
    By viking in forum In-Ground Pool Construction and Repair
    Replies: 25
    Last Post: 07-26-2012, 02:49 PM
  3. Fiberglass Step with Rust Stains
    By Bossone in forum Dealing with Stains & Metals, . . . and 'Minerals' & 'Ions',
    Replies: 7
    Last Post: 07-06-2012, 05:11 PM
  4. brown stains on fiberglass pool
    By PAGUY in forum Dealing with Stains & Metals, . . . and 'Minerals' & 'Ions',
    Replies: 3
    Last Post: 06-27-2011, 07:57 PM
  5. Fiberglass pool stains
    By Pace74 in forum Dealing with Stains & Metals, . . . and 'Minerals' & 'Ions',
    Replies: 2
    Last Post: 10-20-2010, 09:29 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts