Reply With Quote
That's a question for PoolSean or the other SWCG guys.
Is My Cell Dead-Or My Board
My didgital readout is blank most of the time. Its not properly reading the salt when the display does work and the check salt light stays lit. I have cleaned the cell. Look at my circuit board and there is a little discoloration around the black thing in the right upper hand corner. Check cell light stays lit also. Thanks in advance. Im lost.
Last edited by ganny76; 05-07-2013 at 09:53 PM.
18x36 3.5 - 8' depth, IG pool with SWCG; ~21K gal
Re: Is My Cell Dead-Or My Board
That's a question for PoolSean or the other SWCG guys.
Carl
Re: Is My Cell Dead-Or My Board
Can you post a picture of the board? A slight discoloration may be normal from high heat of some components. It would be better to be able to see ow much discoloration there is.
Check all connections to the board and cell, cleaning even the slightest corrosion you might see on any of them.
15' round 4.8K gal Intex AG pool; Intex 633 pump with twin canisters (2500 gph main filtering); Unicel 5315 filter cartridges; Intex 637 pump w/o filter (1000 gph heater circulation); 4hrs; K-2006; utility water; PF:24
Re: Is My Cell Dead-Or My Board
Is this a Goldline unit?
Take a look at this: www.nocellpower.com
It is usually a pretty simple fix.
Mark
Hydraulics 101; Pump Ed 101; Pump/Pool Spreadsheets; Pump Run Time Study; DIY Acid Dosing; DIY Cover Roller
18'x36' 20k plaster, MaxFlo SP2303VSP, Aqualogic PS8 SWCG, 420 sq-ft Cartridge, Solar, 6 jet spa, 1 HP jet pump, 400k BTU NG Heater
Posting Permissions
Bookmarks