Hello,

When in spa mode, the water from the spa is going over the spill way (it never used to do this). This happens weather I use the Aqualink controller in the house or use the 'Service' button in the control panel at the equipment.

I have the JVA 2440 actuators and while in spa mode, I can reverse the little toggle switch on the back of the actuator and it doesn't reverse the valve. If I turn off the controls (Aqualink) and then reverse the valve it works. I can then go into spa mode and everything is correct. The water is contained in the spa. However, I can't leave it like that or the spa will eventually drain into the pool.

My question: does this sound like the actuator is bad since I see the same behavior from the Aqualink controller in the house and the service panel?

Thanks,
Chuck