OK we are back in business as of yesterday evening and I am now circulating again.

The water is clear but by yesterday evening i could feel the surface a tiny bit slimey so I brushed it before and after adding bleach to kick things off.

I added:
5 gal's of 6% bleach after the sun went down and this morning my reading was 10ppm (with last years reagents)
15 bags of salt and my reading shows 3600ppm which is in line with my swcg recommended levels (have not run swcg yet)
I'm almost done with adding 6 lbs of CYA but I need to do upwards of 12 lbs to get to the low end of my swcg recommended level

So here's my test results from this morning:
FC: 10
CC: 0
pH: 7.8
Alkalinity: 160
CYA: NA (new reagents on the way)

Should I adjust anything from those initial readings or should I let it circulate somemore? It's only been mixing up the water for about 15 hours.

Thanks!
-stephen