Motor hesitates and then starts

[pbradley0]

Thanks for the replies. The current rating on the breaker is 20A and is in the power panel next to the motor. The motor is set at 115V and the plate indicates it draws 15A. When the break trips the motor is either just humming or I hear the shaft slowly spinning almost like it is rotating once ever second and then all of the sudden it kicks in like nothing happened. The breaker is the same that I had on my old motor that I had for 10 years the finally died. I replaced it with this motor and it has the same specs as the old one. I was wondering about the thermal cutoff too. When I start it up I always know if its going to trip the breaker within a few seconds because it will do this if it doesn't start rotating at regular speed within 4-5 seconds. If it goes beyond 5 second and is still humming it shuts off. I've also ordered a new cap (because they're a relatively cheap fix) which will be here this weekend. I'll replace it and see what happens.

[Poconos]

A couple of comments. Good idea to try the new cap. To be honest I don't now what the rotation speed, if any, would occur with a shorted cap. I do know that an open in the starting circuit will yield zero rotation. Circuit breakers do sometimes weaken, that is trip at a lower current than the rating. Just an FYI though as the breaker isn't the problem. While you're in the area you may as well clean the switch contacts too. You can use a piece of 600 grit wet-or-dry paper to clean them. Hope the cap is the easy fix.
Al

[pbradley0]

The new cap seems to have done the trick. Not sure why the multimeter test indicated that the old cap was good or why it seemed to be an intermittent problem. Oh well. Thanks for the help.