I was reading a post from July 2011 on this site where the poster said their Aquabot would start and stop intermittently. Our Aquabot Turbo is doing this too, though mostly stopping. The poster stated they ended up fixing the problem rather easily - it was likely caused by the constant twisting of the wire while in operation leaving it broken or frayed. The fix was to cut out a portion of the wire and rewire. Question, how was this done? The wiring is waterproofed/sealed; where the larger cord is connected to the smaller cord that enters the unit, there is a rubber connector of sorts. Was this where they opened up the cord, rewired? And how did they reseal the line?

I'd like to try this resolution myself but was hoping for a more detailed explanation of this process if possible.

Thank you!!