24 agp return leak

[cvoytek]

It looks to be near some white threads on the outside of the pool. As far as I can tell there is the white rubber gastket on the pool/liner side and on the outside some cork maybe and the the white threaded piece. The big white thread3ed piece looks like it can be turned maybe. It almost seems like if I put some silicone around the white threads it would stop but since its pressure side I don't think it would hold.

Here is a pic:

http://putfile.com/pic.php?pic=5/14710202640.jpg&s=f5

It is where the white threads meet that tightening plastic nut (not near the blue silicone.

[cvoytek]

I just went and got a new return. Bummed I have to drain below the return but oh well. Will post if it works.

It looks like there are gaskets on the part I insert pool side as well as the side with the nut as well as the cork piece. Does anyone know if the cork piece goes on the outside or inside of the pool? It was on the outside So I guess I'll do it the same. Just wondering if they installed it wrong last August.

[poolbuoy]

cork on the outside, rubber on the inside...

[cvoytek]

cork on the outside, rubber on the inside...

Thanks poolbuoy! I tested the repair this morning. The new return is sealed but one of the elbows has a slow drip. I can isolate it and re teflon tape/silicone it I think. I just hope I don't break any seals on the return again.