Deja vue! I would swear that's my in-laws' street in London!
That's a lot of work on a very hot day.
Deja vue! I would swear that's my in-laws' street in London!
That's a lot of work on a very hot day.
Oval 12.5K gal AGP; Hayward 19" sand filter; Pentair Dyn 1 HP 2sp pump on timer
[URL="http://www.ellerbach.com/Pool/"]My Pool Pages[/URL]
My pool getting filled by mother nature before I had a chance to install my pool
Doing the final level, I must have checked it a hundred times between the level and transit:
The outside done with crusher dust:
The amount of nuts and bolts just for the side support system:
And finally one side completed:
![]()
Looking good there!
15' round 4.8K gal Intex AG pool; Intex 633 pump with twin canisters (2500 gph main filtering); Unicel 5315 filter cartridges; Intex 637 pump w/o filter (1000 gph heater circulation); 4hrs; K-2006; utility water; PF:24
So got the side supports up:
Then the walls:
Then checked for level, this was nerve racking:
I also checked it with a transit to be doubly sure.
For some reason I didn't snap any pictures of the extruded foam or the coaving going in, maybe my wife did. I will check.
Now the liner is in, and most of the top plates:
But once I got to the last piece, and I had an awful bow in the wall:
I had to "losen" of the top plates to consume this bow. Then I ended up with the top plate not being expanded enough to fit the last piece:
So I losened it a bit more and voila!
I put an inch or so of water in, and tonight will try and get the rest of the wrinkles out, then continue the filling!
![]()
Here's a picture of the foam going in:
![]()
Water going in, liner looking pretty loose:
About 8-10" of water in now, and liner is tight:
Final product:
![]()
Enjoy!
Bookmarks