New AGP Install

[bradatkins]

Last sand truck leaving, thank goodness!



Getting ready to start the leveling, still some extra dirt kicking around. Didn't want to go too deep with the bobcat:



First circle leveled, bubble is inbetween the lines the whole way around:



Second circle started, but it was 35C outside (95F) so I decided to stop. Almost done this circle:



Now to finish the second and third circles, then to make sure there are no gaps underneath the 2x4.

[AnnaK]

Deja vue! I would swear that's my in-laws' street in London!

That's a lot of work on a very hot day.

[bradatkins]

My pool getting filled by mother nature before I had a chance to install my pool



Doing the final level, I must have checked it a hundred times between the level and transit:



The outside done with crusher dust:



The amount of nuts and bolts just for the side support system:



And finally one side completed:

[Charlie_R]

Looking good there!

[bradatkins]

So got the side supports up:



Then the walls:



Then checked for level, this was nerve racking:



I also checked it with a transit to be doubly sure.

For some reason I didn't snap any pictures of the extruded foam or the coaving going in, maybe my wife did. I will check.

Now the liner is in, and most of the top plates:



But once I got to the last piece, and I had an awful bow in the wall:



I had to "losen" of the top plates to consume this bow. Then I ended up with the top plate not being expanded enough to fit the last piece:



So I losened it a bit more and voila!

I put an inch or so of water in, and tonight will try and get the rest of the wrinkles out, then continue the filling!

[bradatkins]

Here's a picture of the foam going in:

[bradatkins]

Water going in, liner looking pretty loose:



About 8-10" of water in now, and liner is tight:



Final product: