Help treating water in childs pool

[Watermom]

You can do both at the same time but just do NOT pour the bleach near the tab and you'll be fine. Many people do use both. Just make sure that your trichlor tabs do NOT have any copper in them.

[chris_c]

How do you know if there is copper? It is not listed in ingredients but all is says is active ingredient 92.4% Trichloro-s-Traizinetrione and the other percentage just says other ingredients.

[aylad]

If there were copper in them, you would see it listed on the ingredient list as "copper pentahydrate" or something of that nature.

Janet

[AnnaK]

Copper is not always required to be listed as an ingredient, depending on how much or how little is in the product. Per the MSDS the ingredients for HTH Dual Action 3" chlorinating tables are:

TRICHLORO-S-TRIAZINETRIONE 90 - 96 %
Copper Sulfate pentahydrate 1.4 - 1.55 %
Aluminum sulfate 4.5 - 4.9 %

[Watermom]

YIKES! That is what I was afraid of and why I asked you to check!

[chris_c]

I'm sorry, I have 2 more questions. After having trouble keeping the bleach to register on test kit I went to the local pool store and they gave me a granular stabilized chlorinator for pools and spas, it says Sodium Dichloro-s-Triazinetrione....100%, provides 56% available chlorine. I asked if it contained any copper and he emphatically said no. Finally my chlorine level is registering good and holding well. I have noticed the past few days the ph level has gradually going down and is now reading 7.2, is that when I add Borax? How much do I add?

I have noticed when I take a reading the chlorine gets darker after it sits a few minutes, why would it darken? Are you supposed to read immediately and empty? or wait a few minutes? The test kit does not say much.

[Watermom]

How much dichlor did you add? Dichlor is fine to use for a short while. It has CYA in it along with chlorine. All pools need some CYA in them but too much will cause a problem. Can you see if your pool store does the disappearing black dot test to test for CYA. If so, let them test it every few days because you do not want your CYA to go over 40-50ppm. (If your Walmart sells an HTH 6-Way test kit (not test strips), it has the CYA test in it so you could do it yourself.

I think the reason you were having trouble keeping chlorine in the pool before was that you didn't have any CYA in there. CYA is kind of like sunscreen for your chlorine. Without some in the water, your chlorine is quickly lost to the sun.

Dichlor is very acidic and will drive your pH down as you have found. Your pool is really small so it is hard to recommend how much Borax to add so I'm going to suggest a little dose and then you can retest the pH after a few hours to see how much it raised it and then adjust and redose with more if needed. Maybe start with 1/8 of a cup? That's a guess on my part. Best I can do.

When reading your chlorine test, read it immediately. The initial color is the result.

By the way, no need to apologize for more questions. That is why we are here!

[PoolDoc]

membership upgraded. -ben