Salt Water Chlorine Generator

[cajunfla]

Maybe a photo form a little farther away would help more. It is hard to see what runs where. Sorry I couldn't be of any real help.

[blonde_b_tan]

I'm sorry about that. Here is another. Thanks for any help you could throw my way. I appreciate it.

Cheers

[blonde_b_tan]

Had to compress image a bit more.

Thanks

[waterbear]

Can't really speak about the Polaris unit specificlly but all the SWG cells that I am familiar with are plumbed after the pump/filter/heater on the return to the pool. Same as an inline chorinator would be. You have to realize that the chlorine level in the cell is very high when it is generating (sort of a 'supershock') and that level of chlorine would not be good for the equipment.

[nater]

From the picture you should have plenty of room to do some re-plumbing for your SWC (IMHO).

PVC is cheap, and really easy to work with (if you have the right tools and you spend some time thinking about your setup). I'd think you could solve your problem for less than $25.

[blonde_b_tan]

Attached is the section where I'd have to fit in a 12 inch cell. I'm no plumber but do have a considerable amount of experience. Thinking of all the 90 deg.
I'd have to install seems to be asking for trouble/leaks. Any suggestions?
I have considered moving the whole Jandy assembly out but this would protrude 14 inches over the sidewalk. Not a viable solution.

Thanks for your reply. I appreciate all the suggestions I can get.

Cheers

[gwrace1]

Another reason the cell is plumbed after the filter, heater, etc is to protect the cell from contamination. I don't think you want all the pre-filter junk going thru the cell.