Unless you take the bromine tablets out QUICKLY, there's no point in adding stabilizer!
Used up bromine turns into bromide. But, chlorine regenerates bromide into bromine, just like an SWCG (salt system) regenerates chloride into chlorine. That's all fine, except for one thing: bromine can't be stabilized!
So:
1. Remove the bromine tablets ASAP!
2. Try to figure out how many pounds you have used.
3. Add 1 gallon of PLAIN 6% bleach (4 ppm chlorine in your pool) in the AM, and then start adding 2 gallons each PM.
4. Test with an OTO kit; if the level the following PM is medium yellow, skip that evening's dose.
If you've used more than a pound of bromine tabs, you may need to consider draining and refilling.
Alternatively, you can use the bleach for a week or two, as described above. High chlorine + sunlight can convert a small portion of the bromide into bromate instead of bromine. Bromate is stable and is not regenerated. Once you have converted all of the bromide to bromate, you'll be able to stabilize your pool.
This is not too hard with some of the straight bromide additives. However bromine tablets are bromo-chloro-dimethylhydantoin, and the DMH (dimethyl hydantoin) apparently interferes with the conversion of bromide to bromate. This problem is what led to the "Once a bromine pool, always a bromine pool" page on PoolSolutions.
So, here are your options:
1. You can simply forget about the bromine, and proceed to operate as if it was a straight chlorine pool. You may, or may not, find that you can not stabilize your chlorine, with the result that you lose all the chlorine in the pool on every sunny day.
2. You can do the bleach as above, and see if you can convert bromide to bromate. If you succeed, you'll be able to operate a normal chlorine pool.
3. You can drain and refill.
4. You can operate a bromine pool -- bromine can not be stabilized, but it's not broken down by sunlight quite as fast as chlorine is.
Good luck!
Bookmarks