My new old pool

[BigDave]

Let it leak a few days, it may just stop. PTFE (Teflon) tape works that way. If it doesn't stop, try re-making the same connection with the same number of wraps of pink teflon tape insted of white. The pink is alot thicker and fills in the gaps better.

[ranand]

Thanks BigDave. I will look for the pink teflon tape. Would that be available at the local home improvement store? Should I be using a silicon type grease at the joints too?

[BigDave]

Yep. Home improvement stores, with the plumbing stuff. I only use silicone grease for o-rings - the kind made for o-rings. I believe I read here recently someone suggest using silicone grease to try to seal suction side leaks.

[ranand]

Bigdave

Pink is my new favorite color, at least with Teflon tape. That worked. The white did not give the seal as this did. I now going to balance my water chemistry

Oval 30 x 15 16000 gallon above ground 1.5hp cartridge filter
Ph 7.5
TA 20
Cya 40
Tds 500
fc 0
Tc0

The leak arose after the fc and tc dropped to 0. The hose also burst and there was a simultaneous algae bloom.

Added 13.5 lbs of sodium bicarbonate. This brought TA to 120 and PH to 7.5. Added 2.4 g of 6% bleach. The chlorine demand was too high and had to add 3lbs of sodium dichlor. Fc went up beyond 10. My kit unfortunately does not show beyond 10. I did get a 310-830 Leslie's kit which is a 2005 and have a k1515 from Amato ordered. Hopefully I can get a real number of fc.

I have got rid of the green and the water is clean. Also cleaned the filter and have been running it for 72h continuously. The overnight fc loss is still more than 1 ppm.

My question is I do have some green at the bottom of the pool still . The pool is in full sunlight for 6h and it has been very hot but given the fc level I thought there would be nothing growing. Do I need 16 ppm fc? I am at a loss since I don't have the fas kit yet.