Kayak Camber bars

[jl_86]

Long time above ground pool owner, first time Kayak pool owner.

The pool is up and running (32'x16'). The questions I have is how much deflection is OK on the upper channel? I followed the instruction manual and installed the specified length camber blocks but I see deflection on the 32' top rails.

Overall we like this pool better than the 24' round we used to have.

Also, is there anywhere I can sell the aluminum decking? I am replacing the Kayak decking with trex. I have the 8'x20' deck complete and the other end and will finish the sides next. Just don't need the Al decking anymore. If not it goes to the metal recyclers.

[BigDave]

I think you should direct this question to the builder or manufacturer. I'm not sure there's much experience with Kayak pools here.

[Jeepman05]

Might try Craig's list. I'm sure there is a recycler that would take them. Interested in pictures of your pool. How did you fasten the coping to the Trex?

[jl_86]

I asked Kayak Midwest. They said a "little" was OK. I guess I was looking for a number on what they consider a little.

On the Trex decking. Routed the end of each board so it fits in the Al channel slot. Working out pretty well so far. Need to finish it all up before I will be satisified. I will try to get pics on here once I am done.

Now I am looking for wedding cake steps. Any suggestions?

[Jeepman05]

Steps are not hard to find. Search for wedding cake pool steps or grand entrance steps and you will get several to pick from.