help with ph and chlorine issue

[dpeterson9]

I have the walmart hth 6 way kit. Ph again 8.2 this am, chlorine .5 - 1 so added 2 more cups this am. TA yesterday was 140. TH was 150 when I checked last.

My return does point up so that could raise the PH, also had 1 1/2 inches of rain in pool last night, and had kids (8) in the pool Sunday...so maybe ph raise is not a big concern.

I have not ever added di-chlor or stabilizer, just the bleach each evening and let the pump/filter run from 9 pm to either 9 am, or all day if no one swims that day. I am adding 4 - 6 cups of bleach each night, and just noticed the last 3 days that ph was 8.2, and it had been 7.8 since I opened the pool in early june. Usually it is just my husband and myself that use the pool, except on weekends when we have friends and kids and grandkids over!
Do you think I should add di-chlor, or stabilizer? Or is just adding bleach each night okay as long as my chlorine and ph levels are good?

Thanks for your help, I have actually been a member for quite awhile, read alot, have never posted before yesterday!

[PoolDoc]

Need to lower the pH some more. Aim for 7.4 or so, before you stop adding acid. It will tend to drift up, given your current TA, so it's better to go a bit low.

[BigDave]

...I have not ever added di-chlor or stabilizer...

You'll probably find that you use less chlorine and maintain more stable FC level if you get some stabilizer in your pool.

I think dichlor would be a good choice for you as it will also lower your pH while it chlorinates and adds stabilizer. A quarter pound (4oz) will add almost as much FC to your pool as 4 Cups of bleach; that would be a good dose size.

Each pound of dichlor should add about 12ppm CYA to your pool. No need to test for CYA until you've added about three pounds.

Please review Ben's Best Guess Chart; it provides Free Chlorine target ranges for varrying CYA ranges. Never let the FC fall below the minimum for your CYA.

If you've used less than a pound of dichlor then you should be in the first target band(0-10). When you've used about a pound of dichlor, start targeting the second band(10-20) and when you're into your third pound, move to the third band(30-50).

Switch back to chlorinating with bleach once you've reached your CYA target.

Be sure to keep an eye on pH as dichlor will cause it to fall (add Borax when it gets to 7.0).

Note: Dichlor is widely being sold with other chemicals mixed in. Be careful to avoid buying dichlor that is not 99% sodium dichloro-s-triazinetrione. We know that unadulterated dichlor is available at Sams Club in a 24lb pack of 1# bags of 100% dichlor shock, from Amazon: Kem-Tek Dichlor 22 lbs, and I've purchased 99% dichlor at my local Leslies in 1lb packs of Chlor-Brite. If you do go to a pool store, don't let them talk you into anything else (except maybe floaty toys).

Be aware, we have seen chlorinating pool chemicals sold at Walmart, Kmart, Costco, and many other local stores that are diluted blends, sometimes with copper and other products with bad side-effects.

[dpeterson9]

Thanks so much for the specific info. I'm off to order di-chlor!

[dpeterson9]

It works, ph down, chlorine level good and not burning off in the sun. Thanks so much for the info!

[BigDave]

Great!
Now treat yourself to a k-2006 and enjoy your pool!