More DE?

[Shifty]

Thanks for the feedback.

I'll open the multiport valve after work and see if the gasket needs to be replaced. If it looks ok, I'll try adding more DE through the skimmer. I think I read somewhere on the forum to put in a little at a time until the PSI rises by 1.

PoolDoc,
Leaves are not going through the grids. The stuff coming out the returns are particles (i.e. dirt and bugs).

On a separate note, I visited the Leslie's closest to my office at lunchtime. After reading this forum for 3 weeks, I felt smarter than the Leslie's workers. HAHA
A worker tried answering a customer's question about the difficulty of maintaining a chlorine level. The worker just tried selling the customer more 3' tabs and didn't ask about CYA levels or if the customer tested their water. I couldn't help myself so I chimed in asking if the person tested their water and what the readings were.

I think I have been reading this forum too much!

[aylad]

Yeah, once you've learned to control your own pool it makes it kinda hard to go to Leslie's and keep your mouth shut

[PoolDoc]

I couldn't help myself so I chimed in asking if the person tested their water and what the readings were.

It's worthwhile to try to zip it -- I've been doing this for over 15 years now, and I can assure you that info from here and PoolSolutions is NOT welcome in pool stores. Since you do want to be able to go back, you might write your item list on a piece of paper, and use Gorilla tape on your lips, before you go in the store.

[Shifty]

How will I know the spider gasket needs to be replaced? Do you have a picture of a failed spider gasket?

[aylad]

When you open up the multiport handle (it's easy to do, and only takes a few seconds), you'll know by looking at it whether it's failed or not. I replace one almost every season, and it's usually torn and scrunched up on one side.

Just turn the pump off, turn the handle halfway between two of the settings to take the pressure off, and then unscrew the screws holding it down. Just pay attention to the orientation of the top of the multiport so you'll know which way to put it back on!

Janet

[Shifty]

If I do need to replace the spider gasket, do you have any advice how to get the old gasket out? I have seen some posts where people said the gasket was glued down to the track.
Is it possible the grids in my filter are not coated with enough DE?

[aylad]

You can get the gasket out with a screwdriver--it's not hard, may just take a little elbow grease. Not sure about the DE question--I don't have a DE filter, but it sounds like a possibility. I'm sure some of the DE filter owners will chime in with opinions about that..