I installed a new centennial 24'x52" A.G. pool. It is made by the makers of Doughboy, but everyone here probably knows that. Anyways a couple of questions, when I installed it I didnt get the ground level, I more less used the sand to give me a level base. Now although the pool is currently perfectly level will I have to worry about the pool settling on the side that has more sand under the liner and walls? I did put 12"x12" concrete pavers under all the verticle support brackets which the instructions said was recommended but not required. I also pushed dirt up against and around the pool so the sand cant work its way out. Do you have any suggestions for reinforcing that, or is it even necessary. If i had it to do all over again I would have got a transit and made sure the ground was completely level. My other question is what automatic pool cleaner do you recommend. My floor seems to have a lot of dips and irregularities in it.