Choosing a new pump/filter for my pool

[ryankenn]

We have something in common then. I use and like the Pentair brand, but I can't get them at my usual discount (Sta-Rite pump discount).

I found out neither can I. The supplier has it setup so that the pool guys can't buy sub/jet pumps and we can't buy pool stuff. Darnit!

[TheGoose]

Ah, then we have the same problem. If you like there is a forum for us W.W. guys. pumpsandtanks.com

[ryankenn]

Ordered the Optiflo 1HP Dual Speed 115V model. Got it for $220 shipped which is fine with me. Just waiting on a C1200 to hopefully score that for about $280 shipped.

Right now my install is all at ground level. Can it be raised up? The inlet of the pump say about 6" below the skimmer, pumping up to the filter at deck level, then back down to the jet? I'm just thinking ease of maintenance for the future, it would be nice to have it in a closet at deck level.

[ryankenn]

Finally got this all installed, and its working beautifully. That cartridge filter did the trick on the algae cleanup. I plumbed it all in with PVC and left it running overnight on HI and the next morning ( with a few bottles of chlorine ) the pool was clear again, vacuumed today and the filter didn't allow an ounce back in and its fully clean. I'm hoping tomorrow I can switch it to LOW where it will stay and we can finally enjoy the pool!

Thanks for the tips, I also ordered a second filter so I can alternate cleaning them. I'm curious if when I shut the pump off and close the valve between the pump and the filter if when I open the air release the water should flow out of the filter through the jet into the pool? I did position the filter such that the casing seperation point is about 12" above the water level in hopes this would be the case and it would mean I lose no water really during filter changes.